This type of cooling tower is using principle of counter flow current between air stream and water. Water is distributed by sprinkler head and sprinkler pipe which is forced to rotate by supplied water pressure

This type of cooling tower is using principle of counter flow current between air stream and water which is same as induced draft counterflow cooling tower (Bottle Type). The difference is water is distributed.

Hot water is delivered from outside to hot water basin located two sides on the top of the tower. Then it will be distributed over pvc fillers which are installed underneath the basins. Cool air is sucked by fan on top.

Forced Draught Cooling Tower: In this type of cooling tower, fan is used to circulate the air. When power plant runs on peak load, it requires a very high rate of cooling water. To rotate fan, it uses motor with speed around 1000 rpm.

The tower design incorporates a RCC basin with number of flower type target nozzles in it and is located at the tower top. The water, by gravity, is dispersed over the fill/splash media uniformly and water is allowed to pass vertically down along these wooden Splash bar.

Pultruded cooling tower is same as counter flow ,induced draft cooling tower , the difference is the structure of this cooling tower is constructed using Pultruded FRP Cannel,The name Pultruded is process for manufacture of fibre-reinforced plastics.

Modular Cooling Tower are same as like Induced Draft Counter Flow Cooling tower, Adding no of cooling tower in series to form a modular cooling tower. This modular cooling tower is used where large amount water flow rate and need better result